"Create OPNsense VM on ProxMox" Saga

Created a VM with hardware from information in one of the many online tutorials on this topic, that is a few years old, and recommends 8GB HDD space on the VM Started the VM with the OPNsense installer DVD ISO mounted on virtual dvdrom drive Went through installer steps to the end where the installer says No space left on device Luckily... I found a forum post where someone mentions the swap partition alone consumes 8GB now, and the VM HDD needs to be 20-30GB Searched ProxMox docs and find the option to expand the size of disk, and enlarge the virtual HDD to 30GB Restarted, but HDD boot "bit" is already set from the "swap partition only" failed install, so the ISO installer won't "try again" and offers no option to wipe the HDD and start over. Decided to drop and re-create the HDD, so I "detached" it, but didn't notice that it hangs around until you "remove" it also, in a separate step. Added a new "blank" HDD... 32GB this time Did another full boot from ISO -> install process... which seemed to work this time (found enough disk space for swap AND install) The reboot at the end boots from installer ISO again. None of the tutorials I found mention that the ISO image must be unmounted before the reboot. Stopped the VM and unmounted the ISO from virtual dvdrom drive Restarted the VM but now the boot process / BIOS won't do anything but PXE network boot. 13 Noticed the initial "unused" HDD and used "remove" to finish getting rid of it. Restarted the VM and went through install process again (not sure why boot bit on the virtual HDD wasn't blocking it this time). Unmounted the ISO from the virtual dvdrom drive again, and rebooted again, but the BIOS is still skipping any attempt to boot from the HDD and tries to do PXE network boot again. Assumed that no boot from HDD might be because the attached HDD is the 2nd one added and has ID=1 (not 0). This might be adjacent to the actual problem (more on that later), but probably wasn't the actual cause. Detached AND "removed" A