Smart Home Garden Irrigation Project

Garden Irrigation System Summary MY project to make a bespoke irrigation system for my home garden, which comes in at under £10 per zone including the actual water delivery method, and is made with relatively easily sourced components. I am a mechanical engineer by training, but not an electrician so interested in hearing pointers on how to make it better. Some of the component and tool links below are AliExpress affiliate links. If you buy through them I earn a small commission at no extra cost to you. Everything listed is what I actually bought and used, or the closest equivalent I could find. This helps me fund some more ambitious but hopefully useful builds in the future. Intro So I have a vegetable patch and some flowers in the garden; it became a bit of a job during the hot days of summer to water the plants in the evening. I didn’t especially mind it but given my love of AI and tech, alongside recent experiments with Home Assistant, I thought there must be a 2026 version of this job. I tried a Wi-Fi-controlled tap, but quickly realised the flow rate was low - due to a small aperture size, and also scaling up with this type of solution to 6 + zones would quickly get expensive and leave me dependent on battery-powered solutions - also not a big win. So as I had begun experimenting with creating my own devices with dev boards etc, I figured, “how hard can it be” and in honesty it wasn’t, just took a bit of trial and error. This guide will be focused on how i would build it today, not all the steps that got me to here. My philosophy Standardised equipment/ components as much as possible Speed of delivery = speed of experimentation Modular where possible Anything can be achieved at any cost, but some of the fun is building something from very little Components Note all water pipes for this project are ½ inch and so connector etc are for that, this corresponds to a ¾ in threaded connector for attaching to pipes Standard UK Hose (½ inch) ¾ inch Threaded Tap Push Fit